I just recently received a Hellcat 380 from I.O. for review. The first thing that caught my attention upon receiving the pistol is that it is made in the USA. I like that. Next, upon opening the box, I immediately noticed that the pistol comes with an extra magazine. I like that too. Also included is a nylon holster that can be used in the pocket, or as a right-handed inside-the-pants holster. There is also a padded nylon zippered carry case included with the hellcat 380. These accessories add value to the pistol, and are items that are not included by the pistol’s comparably-priced competition. I especially like the extra magazine.

Upon examining the Hellcat 380, it is apparent that it is built of quality materials, and the pistol shows no machining marks, inside nor out. The pistol shown here has a nickel-plated slide, but the Hellcat is also offered with a matte blued finish as well. The stainless steel magazines each hold six shots, for a total loaded capacity of seven shots in the pistol. Like most pistols of this type, the slide must pre-cock the hammer, resulting in a smooth trigger pull with single-strike operation. Therefore, if a cartridge fails to fire, the slide must be retracted slightly to again pre-cock the hammer to fire. That is no big deal, as if a cartridge fails to fire, I want to get it out of the pistol immediately. Also, this type of action results in a lighter trigger pull weight than if the trigger had to fully retract the hammer from the fired position. The trigger pull measured a smooth six pounds, five ounces on the test pistol. The Hellcat weighs only nine and one-half ounces with an empty magazine in place. Maximum height, including magazine base and sights, measures 3.615 inches. Overall length is 5.2 inches. Maximum thickness is .782 inches. The barrel length is 2.75 inches.

The recoil spring system uses dual springs and a steel guide rod. The barrel is made of blued carbon steel. The frame, trigger, magazine base, magazine follower, and magazine latch are glass-reinforced polymer. The extractor is nickel-plated, and uses an external flat spring. Disassembly is simple and quick. With an unloaded pistol and the magazine removed, slightly retract the slide and pull out the disassembly pin, allowing the slide to move forward off the frame. To load and fire the Hellcat, chamber a cartridge by retracting and releasing the slide after inserting a loaded magazine. Contrary to the misprint in the owner’s manual, there is no slide hold-open device, but disassembly is not hampered by not having one. The slide does not lock open on an empty magazine.

The Hellcat has a pronounced curve to the back of the grip, and is very comfortable in my hand. I fired the Hellcat with every brand and type of 380 auto ammunition available to me to check for reliable function. I fired a variety of ammunition over the chronograph to check velocities, with the results listed in the chart below. Velocities are listed in feet-per-second. Bullet weights are listed in grains. JHP is a jacketed hollowpoint bullet. DPX is a hollow nose homogenous copper bullet. FMJ is a full metal jacket roundnose bullet. FP is a full metal jacket flat-nose bullet. PB is Cor-Bon Pow’RBall. HC is a hard-cast flat-nose lead bullet. Velocities were taken at an elevation of 541 feet above sea level, ten feet from the muzzle, with an air temperature of ninety-eight degrees Fahrenheit and high humidity. READ MORE HERE